Products

Request Information
Barnes 3SE series horizontal discharge submersible non-clog pumps feature heavy-duty, cast-iron construction with stainless steel hardware. Double-seal units are equipped with temperature sensors and moisture sensors as standard for connection to relay(s) in control panel. Oversized ball bearings are designed for more than maximum pump loads, and are lubricated for the life of the pump.
  • 8 in. (200 mm) horizontal discharge sizes
  • Spherical solids up to 3 in. (75 mm)
  • Motor sizes from 20 hp (14.5 kW) to 200hp(149kW)
  • Enclosed impellers with pump-out vanes
  • High efficiency scroll volute design
  • Oil-filled or air-filled motors and air-filled explosion-proof motors (Explosion-proof motors meet Class I, Groups C & D, Division I design criteria.)
  • Capacities to 5,400 gpm (1,277 m³/h)
  • Heads to 180ft. (55 mm)
Unit of Measure

Manufacturer

 N/A
Barnes

Pump Classification

 N/A Non-Clog Pumps

Series

 N/A 8SE

Discharge

 N/A 8 in200 mm

Motor Power

 N/A 20 to 200 hp14.5 to 149 kW

Impeller Design

 N/A Enclosed (with pump-out vanes)

Volutes Design

 N/A High efficiency scroll

Max. Capacity

 N/A 5400 gpm1277 m³/h

Max. Head

 N/A 180 ft55 m

Max. Solids

 N/A 3 in75 mm

N/A

  • Sump is outside of the building and no above-ground appendage is practical.
  • Overhead clearance is not sufficient to allow for standard vertical column units, such as stairways, underground tunnels, underpasses, etc.
  • Power failures may cause flooding of pump chamber, damaging standard open-type motors.