Products

Request Information
Barnes 3SE series horizontal discharge submersible non-clog pumps feature heavy-duty, cast-iron construction with stainless steel hardware. Double-seal units are equipped with temperature sensors and moisture sensors as standard for connection to relay(s) in control panel. Oversized ball bearings are designed for more than maximum pump loads, and are lubricated for the life of the pump.
  • 6 in. (150 mm) horizontal discharge sizes
  • Spherical sizes up to 4 in. (100 mm)
  • Motor sizes from 7.5 hp (5.6 kW) to 75 hp (56 kW)
  • Enclosed impellers with pump-out vanes
  • Standard-efficiency concentric or high- efficiency scroll volute designs
  • Oil-filled or air-filled motors and air-filled explosion-proof motors (Explosion-proof motors meet Class I, Groups C & D, Division I design criteria.)
  • Capacities to 2,675 gpm (608 m³/h)
  • Heads to 236 ft. (72 m)
Unit of Measure

Manufacturer

 N/A
Barnes

Pump Classification

 N/A Non-Clog Pumps

Series

 N/A 6SE

Discharge

 N/A 6 in150 mm

Motor Power

 N/A 7.5 to 75 hp5.6 to 56 kW

Impeller Design

 N/A Enclosed (with pump-out vanes)

Volutes Design

 N/A Standard-efficiency concentric or high- efficiency scroll

Max. Capacity

 N/A 2675 gpm608 m³/h

Max. Head

 N/A 236 ft72 m

Max. Solids

 N/A 4 in100 mm

N/A

  • Sump is outside of the building and no above-ground appendage is practical.
  • Overhead clearance is not sufficient to allow for standard vertical column units, such as stairways, underground tunnels, underpasses, etc.
  • Power failures may cause flooding of pump chamber, damaging standard open-type motors.