Products

Request Information
Barnes 3SE series horizontal discharge submersible non-clog pumps feature heavy-duty, cast-iron construction with stainless steel hardware. Double-seal units are equipped with temperature sensors and moisture sensors as standard for connection to relay(s) in control panel. Oversized ball bearings are designed for more than maximum pump loads, and are lubricated for the life of the pump.
  • 4 in. (100 mm) horizontal discharge sizes
  • Spherical solids up to 3 in. (75 mm)
  • Motor sizes from .9 hp (.7 kW) to 100 hp(75 kW)
  • Open and enclosed impellers with pump-out vanes
  • Standard-efficiency concentric or high-efficiency scroll volute designs
  • Oil-filled or air-filled motors and air-filled Explosion-proof motors (Explosion-proof motors meet Class I, Groups C & D, Division I design criteria.) to 100 hp (75 kW)
  • Capacities to 1,265 ft. (288 m³/h)
  • Heads to 258 ft. (77 m)
Unit of Measure

Manufacturer

 N/A
Barnes

Pump Classification

 N/A Non-Clog Pumps

Series

 N/A 4SE

Discharge

 N/A 4 in100 mm

Impeller Design

 N/A Open and enclosed (with pump-out vanes)

Max. Capacity

 N/A 1265 gpm288 m³/h

Max. Head

 N/A 258 ft77 m

Max. Solids

 N/A 3 in75 mm

N/A

  • Sump is outside of the building and no above-ground appendage is practical.
  • Overhead clearance is not sufficient to allow for standard vertical column units, such as stairways, underground tunnels, underpasses, etc.
  • Power failures may cause flooding of pump chamber, damaging standard open-type motors.